1) start engine, close doors and turn on the radio

2) plug in the module to OBD2 diagnostic port and menu 1/2 appears on the screen
There are 3 basic modes:
– “factory” – the car will rise to the factory height
– “low” – factory minus 32mm in front and rear
– “custom” – factory minus the value that you select in the menu 2/2 (min -70mm, max +40mm, 1 step = 1 mm, front and rear separately)

3) click numbers 4 or 6 to switch between modes in menu 1/2
to install “low” mode change “sel” to “low” and click 5 for confirmation
Important: don’t plug out the module from the OBD2 port until you receive “OK” message on the screen

3a) if you want to make your own height:
– click numbers 2 or 8 to switch to menu 2/2 “Edit custom mode” and click 5
– use numbers 2, 4, 6 and 8 to choose the height and click 5 for confirmation
– in menu 1/2 change “sel” to “custom” and confirm choice

4) plug out the module
Important: don’t leave the module connected to the OBD2 port

We recommend making a wheel alignment after lowering to avoid increased tire wear, especially if you are going to drive below -40mm.