Suspension Lowering Module V.20|40

MWM hand-held module for Mercedes x167 GLS63 AMG

about the function

The MWM lowering module makes it possible to change the AIRMATIC suspension height. The unit allows to have full control suspension front and rear and adjust using 2 low preset modes.

The lowering setting will be loaded via the ODB2 diagnostic port in the footwell of the car. After plugging the module into the OBD2, the MBUX screen will blink colors depends of modes. After blinking the screen, the suspension will adjust to the new height in 30 seconds. The factory setting will always be stored on the module and the user can set the suspension back to the factory setting. Once the settings are loaded, simply unplug and store for future use.

There’re 3 preset modes in the MWM lowering module:
– Factory (Factory level when our module plugged in for the first time)
– Low (Factory minus 20mm)
– ExtraLow (Factory minus 40mm)

The price includes activation for one car.

Contact us in any convenient way from the Contact Us section, send the VIN number of your Mercedes to make sure that the module is compatible.

Video description

payment

Suspension Lowering Module V.20|40

The suspension lowering software is always uploaded to separate module.
The other Mods for your Mercedes below can only be recorded on another module and you should pay extra $100 for the second module.
For 5+ Mods orders, we offer 10% discount.

FROM:

650.00 $

reviews

frequent questions and answers:

Can I drive a car with lowered suspension?

You can lower the suspension up to 40mm and it’s safe for the ride and the suspension. If lower, it’s only for photos or short rides. We also recommend doing wheel alignment after lowering, if you ride below 35mm the tires will wear out faster without alignment.

Does the car still change height when I change from Comfort to Sport+? 

The suspension will work as usual, but additionally lowered by the module. For example, as before, the suspension will become lower if you switch from Comfort to Sport+ mode (-15mm). If you lower the car by -30mm with the module, total lowering will be -45mm from factory Comfort mode. The same way "raise" button works.

Do I have to keep the module plugged in after lowering?

There is no need to keep the module plugged in all the time. You need to plug it in when you want to change the height or return to the factory height. Afterwards, disconnect the module. 

still having questions?

INSTRUCTION:

To read

1) turn ignition ON (all leds on Instrument Cluster are ON)
TWO times press start button without a brake pedal for cars with keyless go
2) wait for the head unit to get fully loaded (about 20 seconds after you turn ignition ON)
3.1) to get LOW mode:
– plug the module into the OBD-2 port
– observe head unit display for color messages (blue means LOW, green means FACTORY)
3.2) to get EXTRA-LOW mode:
– fully press and hold gas pedal and at the same time not releasing the pedal plug the module into the OBD-2 port
– release the pedal 2 seconds after you plugged the module in
– observe head unit display for color messages (red means EXTRA-LOW, green means FACTORY)
4) plug the module out
5) start engine to let Airmatic system apply changes
6) get off the car and CLOSE all doors. Airmatic ECU will not change height while doors are opened
To return to factory height repeat the above steps and observe screen for green color